ROW 127-130: Sc ea st across, ch-1, turn. At the end of row 130 fasten off.
FLOOR (MAKE 2):
ROW 1: With gray yarn and H hook ch-37, sc 2nd ch from hook, sc ea ch across, ch-1, turn. (36 sts)
ROW 2-10: Sc ea st across, ch-1, turn. At the end of row 10 fasten off.
DOOR:
ROW 1: with gray yarn and H hook ch-51, sc 2nd ch from hook, sc ea ch across, ch-1, turn. (50 sts)
ROW 2-32: In Bk Lp only sc ea st across, ch-1, turn. At the end of row 32 fasten off.
PUTTING IT TOGETHER:
Place one of the castle sides and one of the floor on the foam board. Carefully trace around ea piece. Measure in 1-4” on all sides and use that line as you cutting line. Using the craft knife cut the foam board out.
On the castle board measure in 1-1\2” in on ea long side. Draw a line and then score this line being careful to only cut through one side and foam core. This will form the sidewalls of the castle later. With needle and yarn sew the two-castle facades tog sandwiching the foam board in the center. Do the same with the floor crochet pieces and the cut to size foam board.
Bend the castle’s sides inward. Sew the floor inside these two walls and the front. Sew the bottom of the door to the bottom of the castle. Either leave open or sew snaps to the top of the door and castle to allow it to close.